storystill.blogg.se

Hardwarecanucks hyper 212 evo review
Hardwarecanucks hyper 212 evo review








hardwarecanucks hyper 212 evo review

On the back, you can see through the cooling fins very clearly and see the four heatpipes. If it does, you can simply push the fan up a bit on the cooler. The four 6mm heatpipes have been carefully ground and polished, but of course do not reflect like a nickel-plated surface.įrom the side, you can see the structure of the stacked aluminum fins and the asymmetrical design, so that the cooler does not protrude into the RAM socket on the side with the fan mounted. This serves to improve the heat transfer and is called Heatpipe Direct Touch, or HDT for short. The heatpipes were bent asymmetrically for better RAM compatibility and have direct contact to the CPU again. Great review but tad confused, review shows the 158mm (official spec is 159mm) Hyper 212 EVO fits with both vent & TG panel, but 158mm NH-U12a/s and 155mm Fuma 2 will only fit under vent panel not the TG panel. Here you can see the cooler’s underside still with the protective foil. A 600-2000RPM, 120mm PWM fan is supplied with swept-forward impeller blades. I see the H7 as the Hyper 212 EVO killer.

hardwarecanucks hyper 212 evo review hardwarecanucks hyper 212 evo review

Otherwise the Hyper 212 Evo is a pretty standard tower heatsink. The Cryorig H7 performs about the same, looks much nicer, has a better fan and better compatibility, the mounting hardware is much better, and it includes a very large tube of high quality thermal interface material. On the top of the cooler you can see very good the eight ends of the total of four 6mm heatpipes. Abstract: Coolermasters Hyper 212 Evo heatsink stands 160mm tall, weighs in at moderate 569 grams and packs in four exposed 6mm diameter copper heatpipes on its base. I don't think the CM Hyper 212 is even good enough to cool a 9900K at stock speeds so definitely don't get that. The Cooler Master SickleFlow 120 fan is equipped with 7 rotor blades and is plugged onto the cooler with a previously screwed plastic bracket. The NH-D15 is basically the best air cooler on the market, and is fine for overclocking a 9900K. 1252 rpm and finally with 20 speed at approx. In the following Cooler Master Freezer diagram, you can see from top to bottom the results of the Intel Core i5-10500 CPU at idle with 100 speed, i.e. This is what the new Cooler Master Hyper 212 Evo V2 cooler looks like with a pre-installed 120mm fan. Cooler Master Hyper 212 Evo V2 test results.










Hardwarecanucks hyper 212 evo review